Hand Crank Aluminum Alloy Hand Oil Pump Manual Oil Pump Suction Machine Drum Refueling Not Easy to Get Stuck

1. Put the main pump shaft up and place it on a level2. Install the hand crank on the main pump hole, cover it with a set screw, and tighten the washer3. Install the fixed cover of the oil drum on the straw A and then the straw A-→the straw A-→the straw B4. Put the filter on the bottom of straw B5. Install the lower part of the threaded hole on the main pump and connect it tightly to the6. Install the U-shaped oil outlet pipe on the other end of the main pump and then install the telescopic hose on the U-shaped pipeType: screw pumpModel: 25-32mmMaterial: aluminum alloyDrive mode: manual: wear-resistantApplication: Industrial grade medium: oil pumpPump shaft position: side verticalNumber of impellers: single stageSuction diameter: 32-36 (mm)Discharge diameter: 150-250 (mm)

• [Overall Features] Simple appearance and simple , long-lasting and long service life, good oil sealing .
• [Analysis of the oil pump body] The centrifugal swivel adopts the best composite material to the stuck pump from being easily stuck.
• [Structural features of oil pump] The whole is made of aluminum alloy material, which is easy to install and operate.
• [Sucking pipe] Made of Lu alloy material, the installation and connection are tight and not easy to leak oil. The top filter prevents the inhalation of grease.
• [Suitable scene] Suitable for oil depots, refineries, agricultural machinery stations, fleets, etc., pumping hydraulic oil, , kerosene, diesel, lubricating oil, petroleum and other oils. (It is forbidden to be used in chemical liquids, water and other liquids that will oxidize aluminum.)